*** Version 2.1.1 ***
*********************

- Fixed bugs

1. Hanging up of the whole system under certain conditions (this bug does not exist in version 1.0.0).
2. Sometimes it doesn't display the PortA, PortB and PortC settings properly via the Web interface.
3. Tooltip text with the pulses and timers time left bug on the PortA settings page - it does not show these lables from PortA.12 to PortA.15


- New features added

1. The speed of the web interace is improved
2. After 60 seconds, the TCP/IP user socket is closed if no data is transfered. Without this feature, in some cases the socket may be locked for undefined time.



*** Version 2.0.0 ***
*********************

- Fixed bugs

1. Encrypted RC4 response. Because of this bug the resposne message from DAEnetIP3 to the TCP/IP clinet is not encrypted but transmitted in plain text
2. Added CRC16 checksum (if enabled) to the TCp/IP response when DAEnetIP3 works in TCP/IP <-> serial bridge
3. When DAEnetIP3 works in TCP/IP <-> serial bridge it does not retransmit data coming from serial port to TCP/IP network with serial address different that the serial address of this DAEnetIP3
4. Bug with setting PortB and PortC mode via TCP/IP socket, serial port, VSP and telnet
5. In some cases the schedule mode for PortA does not work correctly - the outputs are not set according the time
6. The web server does not "post" data in some cases
7. Improved reactions during the analog events
8. In some cases the NTP synchronization does not work
9. The NTP GMT parameter is renamed as NTP offset
10. When setting ADC LH,HH,LT,HT it is possible to stroe invalid value
11. Bug with Wi-Fi region when the default settings are loaded
12. When the controller receives command with adress FF, the controller sends respons again with FF. Now it is fixed and it sends it's own address
13. When Time2 is set via command, it will not be saved correctly
14. When Telnet is used, sometimes the controller does not accept the commands correctly



- New features added

1. Web interface improvements
2. When it is used web browser, it is possible to control PortA via Ajax (almost immediately)
3. The timings for PortA can be defined to be in: Seconds, Minutes, Hours
4. When web browser is used and some PortA pin works in Timer or Puls mode, it is shown as tool tip text how many seconds left when the mouse pointer is over the PortA pin state.
5. The PortA states are saved and loaded on init where it is possble to be determineted
6. Linearization for the analog inputs (PortC)
7. The clock is refreshed automaticaly over the web browser
8. It is added date/time when the clock is sinchronyzed successfully lastly
9. There is option which allows the DAEnetIP3 to be synchronized automatically via NTP every 6 hours
10. Added name of the module
11. Added HTTP API commands
12. Added SMTP notifications (E-mails) on events: On boot, Every X minute, on NTP event, on AI event, on DI event
13. In case of Wi-Fi DAEnetIP3 controller, they are added WPA/TKIP(Personal) and WPA2/AES(Personal)
14. Added signal strenght for the wireless signal and indication if the wireless interface is connected to the AP or not.
15. When loading the default settngs, the green (status) led is on when the loading is finished



- Removed features
1. TFTP firmware upgrade (please contact with us and we will send you instructions how to upgrade the controller)


*** Version 1.0.0 ***
*********************

The initial release